BUSing dimmer with 1-10 V signal. On/off relay for leading edge dimming. Equipped with 1 channel.
Technical data ING-RBF10A
- BUSing proportional actuator (regulator) for dimming fluorescent lighting or lighting with electronic ballasts
- Receives orders only via the bus and can be operated from conventional pushbuttons (through a MECing), hand-held remote controls, touch screens or a PC
- Digital regulation by a microcontroller with 200 regulation points
- The regulating ramp (lighting on and off) is set by programming with the Development System software
- Power supply: 230 Vac and 9-16 Vdc from the bus
- Maximum power consumption 2.8 VA at 230 Vac, bus current 25 mA at 12 Vdc when not connected to 230 Vac
- 1-10 V output delivering up to 35 mA, protected against power surges
- One relay output for switching the ballasts on and off, 10 A cut-off, not protected against short circuits
- DIN rail mounting, 4 modules
- Operating temperature from -10 to 55 °C, storage and transport from -30 to 60 °C
- Standards: EN 50090-2-2, UNE-EN 61000-6-3:2007, UNE-EN 61000-6-1:2007, UNE-EN 61010-1
Installation ING-RBF10A
The number of ballasts that can be connected depends on their start-up peaks, and with a high-consumption load a contactor is added to the outputs. The bus uses flexible shielded cable 2 x 0.5 mm² + 2 x 0.22 mm² with a colour code: red +12 V, yellow A, green B, black reference. Low-voltage lines (bus and inputs) run in a separate duct from the 230 V power lines and the outputs.
Product code: ING-RBF10A. See also in the BUSING Dimmers category: DIMMER RGBW ORIGEN – FLUSH-MOUNTED (CONCEALED) and UNIVERSAL DIMMER ORIGEN – 2 CHANNELS.
